สวัสดีครับ ไม่รู้ว่าถามผิดที่หรือเปล่าครับ ตอนนี้ผมใช้ EnGenius ECB-3500 ตอนนี้กำลัง upgrade firmware เป็น dd-wrt โดยใช้ firmware จาก http://www.dd-wrt.com/site/support/router-database#
ผมได้ทำตามขั้นตอนตามนี้ http://www.dd-wrt.com/phpBB2/viewtopic.php?t=44681 ซึ่งพอมาถึง ข้อ15
15. Write bootscript into bootloader
RedBoot> fconfig boot_script true
boot_script: Setting to true
RedBoot> fconfig boot_script_data
boot_script_data:
Enter script, terminate with empty line
>>fis load -l linux
>>exec
Update RedBoot non-volatile configuration - continue (y/n)? y
... Erase from 0xa87e0000-0xa87f0000: .
... Program from 0x80ff0000-0x81000000 at 0xa87e0000: .
พอใช้คำสัง exec มีไม่มีอะไรตอบกลับมาเลย ผมหมายถึงในตัวอย่างพอใช้คำสั่ง exec มันจะตอบกลับมาว่า Update RedBoot non-volatile configuration - continue (y/n)? y
อะไรประมาณนี้ แต่นี้มันไม่มีอะไรตอบกลับมา หลังจาก >>exe มันก็จะเป็น >> ครับ
ผมจึงลองทำต่อข้อ16,17
16. Reboot the device (you may need to power cycle)
RedBoot> reset
17. Now you have successfully loaded DD-WRT firmware into THE DEVICE. Please configure your network interface to “Obtain an IP address automatically”.
หลังจากเปิดเครื่องมา มันก็ไม่สามารถเข้าหน้าเวปเพื่อจัดการตัว rounter 192.168.1.1 ได้เลยครับ
อยากทราบว่าผมทำผิดขั้นตอนตรงไหนครับ แล้วควรแก้ไขอย่างไรดีครับ ขอบคุณครับ